engLisH
Lighting and Operating
To extinguish
Turn control valve to “OFF” position or close ball valve. Close valve on
propane tank while not in use.
Initial break-in procedure: When you light the appliance, you may
notice that it produces heat which may have an odor. if you feel this
odor is excessive it may require an initial three to four hour continuous
burn on high.
WARNING
FIRe RISK – HIGH TeMPeRATUReS
Keep combustible household items away from appliance.
• Do NOT obstruct combustion and ventilation air.
• Do NOT place combustible items on top of or near appliance.
• Keep furniture, draperies away from appliance.
• Do NOT use, lantern fuel, kerosene, charcoal lighter
fluid, bioethanol or similar liquids in this appliance.
• Combustible materials, flammable liquids, or vapors may ignite.
FOR YOUR SAFeTY, ReAD BeFORe LIGHTING
WARNING! If you do not follow these instructions
exactly, a fire or explosion may result causing property
damage, personal injury, and/or loss of life.
a. This appliance can be lit electronically or with a match. When lighting,
follow these instructions exactly.
B. Before lighting, smell all around the appliance area for gas. Be sure
to smell next to the base of the appliance because some gas is heavier
than air and will settle on the floor.
WHAT TO DO IF YOU SMeLL GAS:
• Do not try to light any appliance.
• Do not touch any electric switch, do not use any phone nearby.
• Immediately call your gas supplier from a neighbors phone. Follow gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the fire department.
C. use only your hand to turn the gas control knob on propane tank (if
equipped), never use tools. If the valve won’t turn by hand, don’t try to
repair it, call a qualified service technician. Force or attempted repair
may result in a fire or explosion.
d. do not use the appliance if any part has been underwater.
Immediately call a qualified service technician to inspect the appliance
and replace any part which has been underwater.
e. The gas pressure regulator provided with this appliance must be used.
This regulator is set for an outlet pressure of 10.5in (267mm) water column.
Lighting Instructions
1. depress sparker button and verify a spark is being produced
between the electrode tip and receiving probe.
2. ensure control panel valve is in the “OFF” position and slowly open
valve on propane tank. If using natural gas or whole-house LP, open ball
valve. If not using a control valve, skip this procedure until step 3.
3. depress sparker button and continue holding button while turning
knob to the “ON” position. Release button once flame is present.
WARNING: If the flame does not ignite within 5-10 seconds turn
the gas “OFF” and wait for 5 minutes before re-attempting to ignite.
Failure to follow this instruction may result in a volatile ignition due to
the build up of vapors.
1.
2.
3.
