www.ecosmartfire.com
18
ENGLISH
How to operate the EcoSmart™ Fire
Re-igniting the EcoSmart™ Fire
1. Wait 30 minutes after the fire dies, then check carefully if the Burner is at room temperature. Do not
attempt to re-ignite the Burner until it is at room temperature.
2. Move the slider/hinge so Burner opening is fully open.
3. Allow 5 minutes for any residual fumes to evaporate. Please be aware that if this time is not respected the
ignition will pressurized and therefore stronger. A pressurized ignition can cause serious burns if you are
close to the Burner.
4. Re-ignite as described in “Lighting the EcoSmart™ Burner”.
WARNING!
• Never leave a fire unguarded.
• Only use Denatured Ethanol* in the EcoSmart™ Burner.
• Ignition of the lighting rod should only be performed above and beside the Burner to avoid dripping the
fuel at any stage of the lighting process out of the firebox onto the floor.
• The EcoSmart™ Burner must not be filled at any time with additional Denatured Ethanol* when the
flame is going or when the Burner is hot.
• An inherent danger with Denatured Ethanol* is that the flame produced is almost invisible in normal
daylight conditions or first lit. Being difficult to see, an inexperienced person can easily assume
the Burner is empty and needs filling.
It is potentially lethal to attempt to refill the EcoSmart™ Burner when it is still lit. The result could
easily be an explosion. If it is necessary to refill the Burner, assume it is still burning and go through
the normal procedure of extinguishing the flame. Wait until the burner is at room temperature before
refilling and follow all instructions carefully.