User manual ecoSMART
e-system
68
EN
4. START UP
Before carrying out the first start-up of the machine, pay attention to the following
indications:
1.
Make sure you have installed external switches that disconnect all circuits and
the e-system power supply.
2.
Once you have completed the electrical installation of the e-system, be sure to
turn on the protections.
3.
With the front cover removed, turn the inverter selector to the ON position to
allow DC current input from the panels. After this, press the button indicated on
the figure to bring it to the ON position.
4.
Turn ON the power switch of each battery module starting with the one placed
on the bottom and following those that are placed above (if your e-system is
configured with more than one module).
5.
Finally, you must turn on the switcher inside the electrical panel to feed the e-
system controller.
Illustration 4.1. Positioning the on / off switches in your
e-system.
3
5
4
