FAX Operation (Advanced)
4-12
2
Lift the handset of the telephone.
3
Check if the telephone line has connected to the
fax of the sending system.
When you hear the fax tone
The sending system is on fax.
1
Press the
Status/Job Cancel
key.
2
Press the
On Hook
key.
3
Press [ManualRX] (the
Left Select
key).
Reception will start.
NOTE:
When using a telephone set that can
send tone signals, use the telephone to start the
reception of originals with the remote switch
function. (Refer to
Remote Switch Function on
page 4-13
.)
When you hear a voice from the receiving
system
The telephone line has connected to the telephone
of the sending system. When the conversation is
over, follow steps 1 to 2 above.
After the sending system has started transmission,
the machine starts receiving originals.
4
When reception starts (when the
Processing
indicator on the operation panel starts blinking),
return the handset to its original position.
On Hook:
*
[Manual RX]
Summary of Contents for M6526cdn Type B
