15
REMARK: TO ACTIVATE THE OUTER THERMOSTAT, PRESS BUTTON P4 AND THEN REPEATEDLY
ON P1 TILL YOU REACH THE SETTING “EST“ ON THE DISPLAY. CONFIRM WITH BUTTON P7.
The room temperature will be regulated directly by the wall-mounted thermostat. When the temperature
set is reached, the display will show MODULATION WORK: the stove will work then at lower power to
reduce the consumptionof the pellet.
3.14 Stove Status Menu
In this menu, you can check the correct functioning of the most important components of the pellet
stove.
To enter this menu, proceed as follows:
1.
Keep button P4 pressed for 2 seconds, CLOCK SETTING MENU will appear.
2.
Press button P4 4 times: the display will show STOVE STATUS MENU.
3.
Access using button P6: the display will show the desired screen.
4.
Confirm with button P6 to return automatically to MENU’ 05 STOVE STATUS. This menu
is for use by a service technician to diagnose performance issues and for the customer
when loading pellets into the pellet hopper when the stove has been completely run out
of fuel.
3.15 Working Hours Menu
The WORKING HOURS Menu shows the total hours of work done by the stove. In some cases, the
working hours may not be zeroed. i.e. numbers similar to 5000/15000/25000 may be shown. The
technician will zero set these numbers when lighting the stove for the first time. A non-zero number
does not mean that the stove has worked for all those hours. It is only a setting given by the programme
during first inspection at Ecoteck, before the stoves are packaged and sent.
To enter this menu, proceed as follows:
1.
Keep button P4 pressed for 2 seconds: CLOCK SETTING MENU will appear.
2.
Press button P4 5 times: the display will show WORKING HOURS MENU.
3.
Access with button P6: the display will show the screen desired.
4.
Confirm with button P6 to return automatically to MENU’ 06 WORKING HOURS MENU’.
MOTOR RPM
TEMPERATURE OF SMOKE
STATE OF SCREW
2000
130°C
SCREW 0
STATE