Ser in u s 3 0 B en u tzer h an d b u ch 2 .1
Seite 100
Umgebungsdruck auf Meereshöhe ausgesetzt wird, beträgt die Spannung ca. 4 V. Wenn der
Sensor aber unter Vakuum arbeitet, ist die Spannung auch niedrig, zum Beispiel 0,5 V. Wenn an
den Prüfkontakten eine Spannung gleich 0 oder negative Spannung gemessen wird, dann ist
wahrscheinlich ein Fehler im Modul und es soll ausgetauscht werden.
Abbildung 51 – Kontakte zur Prüfung der Druckmessung
Abbildung 52 – Typischer Messwert der Prüfkontakten für die Messung des Zellendrucks
6.4.10
Batteriewechsel
Ein Wechsel der Batterie (BT1) auf der Hauptplatine könnte erforderlich werden. Sollte sich die Uhr
zurücksetzen oder bei ausgeschalteter Stromversorgung nicht weiter laufen, ist die Batteriekapazität
erschöpft. Die Batterie sollte mit dem richtigen Batterietyp getauscht werden, d.h. eine CR2025 3 V
Lithiumbatterie. Sie wird folgendermaßen korrekt installiert:
1.
Schalten Sie das Gerät aus, öffnen Sie den Deckel und entfernen Sie die zwei Schrauben, die die
Hauptplatine befestigen.
2.
Klappen Sie die Hauptplatine hoch. Die Batterie (BT1) befindet sich gegenüber von der
Hauptplatine.
3.
Heben Sie die Befestigungslasche der Batterie mit einem kleinen flachen Schraubenzieher und
ziehen Sie dabei die alte Batterie ab.
4.
Setzen Sie nun die neue Batterie mit dem positiven Pol (+) nach oben ein.
Summary of Contents for Serinus 30
