Ser in u s 3 0 B en u tzer h an d b u ch 2 .1
Seite 112
Einbau des Geräts
1.
Entfernen Sie die Gummifüße vom Analysator (wenn befestigt).
2.
Trennen Sie die zwei Profile der Gleitschiene, indem Sie auf den schwarzen Klemmen auf der
Schiene drücken und das innere Profil entfernen (siehe Abbildung 58).
Abbildung 58 – Trennen der Gleitschienen
3.
Befestigen Sie das innere Profil an jeder Seite des Analysators mit Hilfe der M4 x 10
Linsenkopfschrauben – drei an jeder Seite. Stellen Sie sicher, dass Sie die Langlöcher treffen.
Drücken Sie die Schiene nach unten, sodass die Schrauben im oberen Bereich der Langlöcher
positioniert sind. Damit wird gewährleistet, dass Ausbuchtungen auf der unteren Seite des
Analysators auf eventuell eingebauten Blindplatten nicht stößt (siehe Abbildung 59).
Abbildung 59 – Befestigung der inneren Profile auf dem Gehäuse
4.
Schrauben Sie die Rackbefestigungsadapter zu den Enden der äußeren Schienenprofile mit den
M4 x 10 Linsenkopfschrauben, Scheiben und Kontermuttern zu. Ziehen Sie die Schrauben noch
nicht ganz fest, da die Länge des Racks noch angepasst werden muss (siehe Abbildung 60).
Summary of Contents for Serinus 30
