Take the manifold assembly (B) and ensure that the
rubber seal (A) is correctly located into the recess.
Push the center support tube (C) securely into the
recess on the underside of the manifold. Remove
each of the six ceramic filter candles (E) from the
protective wrap and check that the O-ring seal (D)
is located fully onto the threaded mount of the
filter candle. Screw the threaded mount into one of
the holes in the underside of the manifold until the
washer resistance is felt and the moulded cap just
touches the ring on the underside of the manifold.
DO NOT OVER TIGHTEN!
Repeat for all six candles. Take the base moulding
(F), ensure the rubber seal (G) is located correctly
into the recess and push the base securely onto the
support tube (C) to complete the assembly. Now
the unit is ready for the main installation.
Eco Solution water purification system is easy to assemble. However, it is
advisable to use a certified plumber to install the system. Eco Solution should
be installed on the water intake as shown below.
ASSEMBLY
CARTRIDGE ASSEMBLY
2
Water intake [
2
]
Main stop valve [
1
]
Purified water
out [
3
]
A
B
D
E
C
F
G
