•
•
•
•
•
•
Shut off the main water intake with the main stop valve [
1
] or by the main tap.
Assemble the unit on to the water intake grid. There are several alternatives of how to
do this, depending on the existing grid system.
Place the unit onto the water intake (after the pump, if there is one)
NOTE; make sure there’s a 10 cm clearing underneath the unit. This space is necessary
to be able to open the units for cleaning/maintenance/changing the filters.
Open the water intake [
1
]. Open a tap connected to the same grid and let the water
run to waste for about ten minutes before use( in order to remove unwanted particles).
Ensure there is no leakage from the unit or it’s couplings. If there is a leakage, ensure all
O-rings are assembled correctly to make a proper seal.
For new filter candles, the maximum flow rate will be achieved once the candles are
fully saturated; to allow the filter candles to be conditioned to the source water allow
the unit to stand unused for a further 24 hours and then flush for a further 10 minutes
to waste.
The filtered water can now be used for drinking and preparing food. If the filter has
been standing unused for more than 3 days, it is recommended that the water be
run to waste for 1 minute before use.
GENERAL USE
3
USER MANUAL
UNIT ASSEMBLY
The filters in your Eco Solution water purification system must be cleaned from time to
time. Cleaning is easy – no plumber or other service personnel is necessary. The quality
of the water source decides how frequent it is necessary to clean the filters.
The filters have to be replaced if the purification system delivers no water at all, or when
the water flow is low even after cleaning the ceramic filter. Filter change will probably be
necessary after approx. 50 000 – 100 000 liters or after about 12 months of daily use
(water source dependent).
Soon after the purification system has been put to use for the first time you will
experience a noticeable drop in the water pressure. This is expected due to residue
(from production) from the High performance filter are clogging up the ceramic filter.
A cleaning of the ceramic filter is thus necessary relatively short after put to use the first
time, or after filter change. The system will deliver purified water in a much longer
period, after this first removal of production residue. The quality of the water source
decides how frequent it is necessary to clean the filters.
MAINTENANCE
