21
ECOWATER
S Y S T E
M S
Service Information
OTHER SERVICE
HARD WATER BYPASS
(hard water ‘‘bleeds’’ into
conditioned water supply).
1.
Defective inlet disc, seal, or wave washer (see pages
26 and 27).
2.
Missing or defective o--ring(s) at resin tank to valve con-
nection.
WATER LEAKS FROM DRAIN HOSE
(during ser-
vice).
1.
Defective inlet disc, seal, or wave washer.
2.
Defective o--ring on inlet disc shaft.
3.
Defective outlet disc, seal, or wave washer.
FLOODED SALT TANK
1.
Nozzle venturi plugged.
2.
Defective valve seals.
3.
Restricted or plugged backwash/fast rinse controls.
4.
Restricted or plugged drain line.
WATER HAS SALTY TASTE
1.
House water pressure low (adjust pump, if well system).
2.
Partially restricted valve drain hose, top distributor,
backwash flow plug, resin tank internal riser, or bottom
distributor.
WIRING SCHEMATIC
24VAC
TRANSFORMER
GND
OUT
+5
TURBINE
SENSOR
NC
NO
PWA on
back of controller
VAC
24
6 pin connector
white
POSITION
SWITCH
M
24V
TANK
LIGHT
110 V
60 Hz
FOR FUTURE REFERENCE, ENTER THE FOLLOWING INFORMATION
MODEL NO.
DATE CODE
WATER HARDNESS
GPG
WATER HARDNESS SETTING
(see page 15)
SERIAL NO.
INSTALLATION DATE
IRON CONTENT
PPM
on rating decal
on shipping carton