15
ECOWATER
S Y S T E M S
Customizing Features / Options
FIG. 20
FIG. 21
FIG. 22
OPERATING IN MANUAL CLEAN RINSE MODE
Clean Rinse cycles will run automatically, unless the automatic Clean Rinse
function has been disabled. If this function has been disabled, it will be neces-
sary to manually initiate any Clean Rinse cycles. It is recommended that a
Clean Rinse cycle should be run at least once each month, or more frequently if
necessary.
A manual Clean Rinse mode may be used when a drain (required for automatic
Clean Rinse) is not available. However, it is recommended that automatic
Clean Rinse be used if the drain requirements can be met.
IMPORTANT
: During the Clean Rinse cycle, whether manually or automatically
initiated, water will flow from the valve drain port at 3 gallons per min. for 3 min-
utes. If a permanent drain line has not been installed, provisions must be made
for the drain flow prior to initiating a Clean Rinse cycle You must have empty
containers ready that will hold at least 12 gallons of water.
DISABLING AUTOMATIC CLEAN RINSE
To disable the automatic Clean Rinse function:
1
. Press and immediately release the RECHARGE button (pressing and holding
the button a few seconds would initiate a Clean Rinse cycle).
2
. “VAC” will flash in the display, as shown in Figure 20 indicating that the
Central Water Filtration System is in the manual Clean Rinse mode (the auto-
matic Clean Rinse function has been disabled).
MANUALLY STARTING A CLEAN RINSE CYCLE
To manually start a Clean Rinse cycle:
1
. If the drain line is not set up to discharge into a drain, you must have empty
containers ready that will hold at least 12 gallons of water.
2
. Press and hold the RECHARGE button for a few seconds, until “RECHARGE
NOW” flashes in the display, as shown in Figure 21.
3
. When the Clean Rinse cycle is complete, the Central Water Filtration System
will remain in the manual Clean Rinse mode.
RE-ENABLING AUTOMATIC CLEAN RINSE
To return the Central Water Filtration System to its automatic Clean Rinse func-
tion:
1
. Press and immediately release the RECHARGE button.
2
. The flashing “RECHARGE OFF” on the display should be replaced by the
normal time of day screen, as shown in Figure 22.
POWER OUTAGE MEMORY
If electrical power to the Central Water Filtration System is lost, “memory'' built
into the controller circuitry will keep all settings for up to eight hours. While the
power is out, the display is blank and the Central Water Filtration System will
not Clean Rinse.
When electrical power is restored, you have to reset the time of day only if the
display is flashing. The Clean Rinse TIME never requires resetting unless a
change is desired. Even if the clock is incorrect after a long power outage, the
Central Water Filtration System works as it should to keep your water treated.
However, Clean Rinse cycles may occur at the wrong time of day until you reset
the clock to the correct time of day.
NOTE:
If the Central Water Filtration System was in a Clean Rinse cycle when
power was lost, it will now finish the cycle.
