23
ECOWATER
S Y S T E M S
Optional Remote Unpacking & Installation
UNPACKING
The EcoWater Systems HydroLink™ remote is shipped
from the factory in one carton. Thoroughly check for
possible shipping damage and parts loss. Also note
any damage to the shipping carton. Notify the trans-
portation company if damage is present. EcoWater
Systems is not responsible for in-transit damages.
Remove and discard (RECYCLE) all packing materials.
ITEMS INCLUDED WITH SHIPMENT
FIG. 91
Remote (including
Battery Cover)
Support
3 Batteries
(AA size)
INSTALLING BATTERIES
1
. Remove the battery cover from the back of the
remote.
2
. Install three (3) AA size batteries, making sure that
they are oriented to match the
Æ
and
–
markings
inside the battery compartment (See Figure 92).
3
. Snap the battery cover back in place.
FIG. 92
FIG. 94
INSTALLING THE SUPPORT
The EcoWater Systems HydroLink™ remote is shipped
with a teardrop-shaped support to hold the unit at an
angle when placed on a horizontal surface.
1
. Snap one of the support’s two tabs into the rectangu-
lar slot on the back of the remote’s case (See Figure
93).
OPTIONAL WALL MOUNTING
The EcoWater Systems HydroLink™ remote (without
the support) may also be mounted on a wall. If this
option is desired, install two fasteners (not included) at
a convenient height, spaced 6-1/8” (156 mm) apart
(See Figure 95).
FIG. 95
FIG. 93
Support
has 2 tabs
Slot in
battery cover
Battery
Cover
3 Batteries
(AA size)
6-1/8”
(156 mm)
2
. The angle may be adjusted by reorienting the sup-
port in the battery cover (See Figure 94).
NOTE:
When replacing batteries in a remote that was
previously connected to a conditioner/refiner, it
is not necessary to reconnect the remote and
conditioner/refiner.