22
ECOWATER
S
Y
S
T
E
M
S
Service Information
C.
While in this diagnostic screen, the following in-
formation is available and may be beneficial for vari-
ous reasons. This information is retained by the
computer from the first time electrical power is ap-
plied to the face plate.
---- Press (
↑
) to display the number of days this face
plate has had electrical power applied.
---- Press (
↓
) to display the number of regenerations
initiated by this face plate since the model code num-
ber was entered.
3.
Press the SELECT keypad and hold 3 seconds
until...
S5 25
shows.
This code identifies the softener nominal capacity
size. If the wrong number shows, the softener will
operate on incorrect programming. Do the following
as needed.
Return the present time display:
Press the SE-
LECT keypad.
Change the model code number:
To display the
correct model code number, press the (
↑
) UP or
DOWN (
↓
) keypad. Press SELECT, and
reset the
timer.
NOTE:
If the face plate is left in a diagnostic display (or a
flashing display when setting times or hardness),
present time automatically returns if a keypad is
not pressed within 4 minutes.
FACE PLATE REPLACEMENT:
Be sure the
valve is in service position (observe valve
cycle indicator) when replacing the face plate.
If, after installing and programming the replace-
ment face plate, the valve
is not
in service posi-
tion, do the following to assure correct cycle
orientation, or timing, between the face plate and
valve.
Use the MANUAL ADVANCE procedures, page
23. With the RECHARGE keypad, advance
through the recharge cycles until the valve stops
in service position, and RECHARGE no longer
flashes in the timer.
NOTE: The valve motor may automatically drive
through several valve positions while searching
for service. If an error code occurs, unplug the
transformer, then plug in again.
CAM
MOTOR
position
markers
(valve in
service)
