12
Programming Face Plate Timer
ECOWATER
S Y S T E
M S
FIGURE 10
DOWN
keypad
UP
keypad
display
SELECT
keypad
RECHARGE
keypad
VACATION
NOW (HOLD)
I.
When the transformer is plugged in, the model
code HAIIF shows in the face plate display for the
first few seconds. The model code is followed by a
test number (example: J1.1). Then the display will
flash “12:00 PM” and the words “PRESENT TIME”.
Set the present time of day as follows:
A. Set Time of Day
1. Press the UP or DOWN keypads until the correct
time of day shows, being sure AM or PM shows in the
display.
NOTE:
Press and quickly release the keypads to
slowly advance the display. Hold the kaypads down
for fast advance. This procedure applies for all fol-
lowing settings.
2. Press the SELECT keypad once to set the present
time and advance to the next set up screen.
B. Set Days to Recharge
1. This setting is the number of days the filter will go
between recharges. The default setting is 3 days,
with a maximum setting of 99.
2. Press the UP or DOWN keypads until the correct
number of days between recharges is shown in the
display.
3. Press the SELECT keypad once to set the days
to recharge and advance to the next set up screen.
NOTE:
See the chart on the following page to deter-
mine the frequency of recharges. Find the number
of people living in the household, and then going
across the chart, find the amount of iron (in parts per
million) that is in the water supply. The number of
days that shows is the number of days the filter
should be set for recharges.
