Programming Face Plate Timer
ECOWATER
S Y S T E
M S
3
11
FIGURE 10
display
display
display
CURRENT TIME
AND DAY keypad
RECHARGE TIME
keypad
RECHARGE DAYS
keypad
SET keypad
VACATION / RECHARGE NOW
keypad
1.
When the transformer is plugged into the electrical
outlet, 12:00 AM, SUnday begins to flash in the time
display. Set the
time of day
and present
day of
week
as follows:
A. Set Time of Day
1. Press the CURRENT TIME AND DAY keypad
once. The hour display continues to flash.
2. Press the SET keypad until the present hour of the
day shows in the display. Be sure AM for morning
hours, or PM for afternoon and evening hours
shows.
Note:
Press SET and quickly release to move the
hour display ahead one at time to the correct hour.
Or,
hold
the SET keypad to move the display ahead
two hours each second, to the correct hour.
3. Press CURRENT TIME AND DAY keypad once to
steady the hour display, and minutes begin to flash.
Press SET until the correct minutes show in the dis-
play.
4. Press CURRENT TIME AND DAY keypad again
to steady the minute display (day will begin flashing).
B. Set Present Day of Week
1. Press the SET keypad to set the present day of
the week in the display.
Note:
Press SET and quickly release to move the
day display one at a time. Or,
hold
the SET keypad
to move the display ahead two days each second.
2. Press the CURRENT TIME AND DAY keypad
again to steady the entire display.
C. Set Days and Time of Backwash
Note:
The timer is factory set (default time) for
Monday, Wednesday, and Saturday backwashes,
beginning at 12:00 AM. If you have an Eco Water
conditioner or another filter installed, the backwash
timer and/or days should be offset to assure ade-
quate water flow and pressure. For example, set the
filter to start backwash at 12:00 AM, or 4:00 AM, if
the conditioner is set to begin recharge at 2:00 AM.
1. Press RECHARGE TIME keypad once, to display
the factory set backwash days and starting time
(flashing). To change the backwash start time, do
step 2 following, otherwise to to step 3.
2. Press the SET keypad until the desired backwash
starting time shows in the display.
Note:
Press SET and quickly release to move the
display ahead one hour at a time. Or,
hold
the SET
keypad to move the display ahead two hours each
second.
3.
Press the RECHARGE DAYS keypad and
SUnday begins to flash.
...If you
want
backwashes on Sunday, press the
SET keypad to display
ON
.
NOTE:
One backwash each week is usually suffi-
cient to keep the mineral bed clean and expanded.
If the water supply contains iron, or high sediments,
additional backwashes may be needed.
...If you
do not want
Sunday backwashes, press
SET keypad to display
OFF
.
