10
Electric scooter ER
Battery and Charger
Each EcoWHeel electric scooter has its battery and charger. Each scooter and its parts also have
their serial number.
Never charge the battery with a charger other than the one that belongs to the scooter! Otherwise
there is a serious risk of damage or destruction of the battery. Our company is not responsible
for destroying the battery or charger if you do not follow this instruction.
Lithium battery
Charge the battery to 100% before using the scooter for the first time.
To make sure you reach your destination, we recommend that you recharge the battery to full
capacity if the battery indicator shows only two links on the display.
If you do not use the scooter for a long time (more than 2 months), recharge the battery to about
60% of capacity.
The battery has undercover protection. Nevertheless, the battery may undercut during very long
storage without continuous charging or while driving, when the display indicator previously
displayed a low battery capacity, the display suddenly goes out while driving, and you turn the
scooter back on and hold the throttle. If the display goes out due to low battery capacity, it is an
underrun protection signal - then do not turn the electric scooter back on and continue to run
again, otherwise the battery may be damaged.
If the undercharged battery does not respond even when connected to a charger, contact your
dealer.
The battery may also be damaged by abnormal exposure to water, shock, etc. In that case
it is not covered by the warranty period.
Contact your dealer if:
•
You smell a strange smell from the battery
•
the battery becomes extremely hot during driving
•
the battery appears to be leaking
Charger
The smart charger supplied to the scooter automatically disconnects the charger when the battery is
100% charged - it has overcharging protection. For reasons of safety and optimum battery life, we do
not recommend leaving the scooter attached to the charger after the battery is fully charged.
Charging procedure
1. Remove the protective cover of the charging connector (socket) located on the right side of the
scooter step and insert the connector (plug) of the charger.
2. Connect the charger to the mains (220 V).
3. The charging process works when the LED on the charger is lit red. When the battery is charged,
the LED light turns green.
4. After charging the battery, disconnect the charger from the power outlet and the charger connector
(plug) from the scooter connector.
5. Close the charging connector on the scooter with the protective cap.
