4
Electric scooter ER
Safety Notice
1. The scooter is designed to carry one person. The recommended age is from 16 years. The
device is also not intended for people of advanced age or for pregnant women.
2. Wear a helmet and other protective gear, incl. footwear.
3. Before the first ride, try the scooter control in the open air.
4. Avoid dangerous maneuvers or one-hand steering while driving.
5. Do not drive into water, oil or frozen surfaces.
6. Do not use the scooter in frost than -5 ° C.
7. Do not immerse the scooter in water deeper than 3 cm. This may cause the battery or motor to
short circuit.
8. If you do not use the scooter for a long time, recharge the battery to about 60% of capacity.
10. Always make sure that you do not violate local regulations, laws and regulations before
using the scooter. If in doubt, contact your local authorities.
11. Check that all parts are well held and that the screws are not loosened. Ex. tighten them or
contact a service center.
12. Do not make unauthorized modifications or maintenance work to reduce the safety of the
equipment.
13. Check the product regularly for wear. Replace worn parts immediately.
14. Follow the manual for maintenance and use. Do not disassemble the device yourself.
15. Check the battery condition before driving. If it is not fully charged, do not start driving.
16. The device is for personal use only. Commercial use is not allowed.
17. Keep your feet relaxed and your knees slightly bent when driving on a flat surface.
18. Other activities (phoning, listening to music) can significantly reduce your driving attention.
19. Do not exceed the maximum load capacity.
Before the First Ride
Check / set before the first ride:
Front light
The light is not attached to the scooter for transport safety reasons. Screw it to the frame, set it in
position and tighten the fixing screw.
Brake levers
Move the brake levers so that they are comfortable to press and tighten the brake lever retaining
bolts.
Display
Loosen the display clamp retaining bolts and turn the display so that it is clearly visible and the
throttle lever is operable - then tighten the mounting bolts. Remove the protective film from the
display.
