5
Electric scooter ER
Quick-release sleeve
The handlebar quick-release sleeve should be adjusted to resist when closing, and the
handlebar does not slide down when pushed from above. If the sleeve is too loose, open it,
tighten the knurled nut on the screw axis and close the sleeve.
Brakes
Brakes are factory-set. If the mechanical (disc) brakes are not suitable for you, you can
adjust them - but we recommend you to do so after a
few trips, until the brakes go:
a / braking intensity is adjusted with
the locking screw on the brake lever (1) or the brake
mechanism (2). By loosening the lock nut and
unscrewing the locking screw, the braking intensity will
be higher and the lower will be lowered by screwing in.
Then tighten the lock nut. Ex. you can also loosen the
cable fastening screw (3), move the cable and retighten
the screw.
b / brake pad centering possible
adjust the locking screws (4) on the brake mechanism
- gently loosen the screws, center the brake so that the
brake disc is centered between the plates, tighten the
locking screws.
The handlebar folding mechanism
Handlebars may have a slight fold in the folding
mechanism.
If the play is too large, it can then be adjusted
a locking screw (5) located in the joint mechanism (when
the handlebars are folded, the screw is visible).
Gently turning the screw outward will reduce the clearance a
vice versa.
If the screw is turned too far, the handlebar will not go
fold - in which case the screw must be turned inward.
Tire pressure
The optimum tire pressure is 40-50 p.s.i. / 2.8-3.4 bar.
Charge the battery
Charge the scooter to 100% capacity before the first ride - the
control LED on the charger is green.