16
Reset Mode:
Hold the black button for about 10
seconds till the red light and blue light flash
simultaneously for three times will reset the
gateway to factory settings. The history data, Wi-
Fi settings, calibration etc. will be all lost and
need to be setup again via WS View app.
Note:
When powered up, and when there is no
valid Wi-Fi configuration (including the
very first time), the Wi-Fi status LED
will be rapidly flashing. It means that
the
gateway
is
in
the
Wi-Fi
configuration mode. Use the mobile
application
to
complete
the
configuration process.
Note:
If you purchased optional sensor(s), you
may power up the new sensor(s) at any
time and use mobile application’s live
data view to confirm whether the sensor
has been added successfully. If this does
not appear the case, also check the
Sensor ID
page to see if the sensor’s ID
has been registered.
Summary of Contents for GW1000
