8
4 Set up Guide
To complete assembly you will need a Philips screwdriver (size PH0) and a
wrench (size M6; included in package).
Note:
We suggest you assemble all components of the weather station,
including gateway in one location so you can easily test
functionality. After testing, place the outdoor sensor package in the
desired location. Note, however, that movement during assembly,
and movement after assembly can cause the rain sensor to “falsely”
register rain. It is therefore best if you do not connect the gateway to
any Internet services until you have reset these false readings using
the gateway. The errant values may be hard to remove from Internet
services if you do not reset first.
Attention:
Ensure batteries are installed with correct polarity (+/-)
Do not mix old and new batteries
Do not use rechargeable batteries
If outdoor temperature may go below 32F or 0C for prolonged periods,
Lithium based batteries are suggested over alkaline type batteries for the
outdoor sensor array
4.1 Sensor Package Assembly
See Figure 2 to locate and understand all the parts of the outdoor sensor
package once fully assembled.
Figure 2: Sensor assembly components
Summary of Contents for GW1001
Page 26: ...26 Figure 14 Weather Services uploading setting screen ...
Page 30: ...30 Graph display List display ...
Page 42: ...42 You may view your weather station data by pressing your device on this screen ...
Page 46: ...46 https itunes apple com us app pws weather station monitor id713705929 ...
