10
4
Set up Guide
To complete assembly you will need a Philips screwdriver (size PH0) and a
wrench (size M5; included in package).
Note:
We suggest you assemble all components of the weather station,
including console in one location so you can easily test functionality.
After testing, place the outdoor sensor package in the desired location.
Note, however, that movement during assembly, and movement after
assembly c
an cause the rain sensor to “falsely” register rain. It is
therefore best if you do not connect the console to any Internet
services until you have reset these false readings using the console.
The errant values may be hard to remove from Internet services if you
do not reset first.
Attention:
•
Follow suggested order for battery installation (outdoor sensor first,
console second)
•
Ensure batteries are installed with correct polarity (+/-)
•
Do not mix old and new batteries
•
Do not use rechargeable batteries
•
If outdoor temperature may go below 32F or 0C for prolonged periods,
Lithium based batteries are suggested over alkaline type batteries for the
outdoor sensor array
4.1
Sensor Package Assembly
See Figure 4 to locate and understand all the parts of the outdoor sensor
package once fully assembled.
