63
9.7 Editing Rain totals
When on the “Live Data” screen, you can press the “More” button
(upper right) to edit the rain totals if needed.
9.8 Device Settings
On the Live Data page, press “More” on the top-right, and select
“Device Settings” to set the following:
Select sensor type.
Set time zone.
Reboot Device.
Reset to Factory Settings.
Firmware upgrade (only display when new firmware is
available)
9.9 Sensor ID
On Live Data page, press More and select “Sensors ID” to set the
following:
View sensor ID, signal strength and battery power condition. 1-4
bars means 1-4 successful successive signal receptions without
missed ones.
Register the sensor when offline.
Enable or disable the sensor.
Input the Sensor ID when offline.
10 Maintenance
The following steps should be taken for proper maintenance of your
station
1. Clean the rain gauge once every 3 months. Rotate the funnel
counter-clockwise and lift to expose the rain gauge mechanism, and
clean with a damp cloth. Remove any dirt, debris and insects. If bug
infestation is an issue, spray the array lightly with insecticide.
