Detailed Programming Instructions
The following detailed steps will guide you through customizing and programming your 0-10V Ramp Timer.
Please be sure to follow our Quick Installation Guide and set the clock before following the below steps.
Programming Individual Lighting Channels
The 0-10V Ramp Timer features two channels of lighting which can be independently controlled. Channel 1/Line 1 should be connected to your
blue spectrum lights for dawn/dusk/actinic/moon lighting; Channel 2/Line 2 should be connected to your white spectrum lights for daylight.
SUNRISE/SUNSET FADE
- The duration of the ramp up and dim down (0-30 minutes)
To reset the memory settings to the factory default, press
DEFAULT
for 5 seconds (see pg. 5).
Default
This will reset the controller memory for all four memory settings.
Determines what time your lights will begin to ramp up from 10%
Determines what time your lights will begin to ramp down to 10%
The maximum brightness setting (from 10%-100%)
The minimum brightness setting (from 10%-100%)
0-10V Ramp Timer
Instructions
Page 8 of 10
