17
Assembly Instructions
1.
To install the four fascia mounting bolts:
a.
Locate supplied bolts and washers from kit bag.
b.
Place washers on bolts.
c.
Screw mounting bolt with washer into chassis
leaving approximately 1” (25mm) to hang fascia.
2.
Insure white panel fasteners holding fascia polystyrene
are pushed firmly in, fasteners may have loosened in
transit.
3.
Lift fascia onto chassis mounting bolts. Align key hole
brackets with mounting bolts. Slide fascia forward to
lock into position.
4.
On Cassette 18 - 24 units connect vane motor plug.
Plug into socket connection on chassis.
a.
Insure polarized connector (2 position) is in proper
orientation and connected.
b.
Route wires to prevent them from becoming trapped,
cut, broken or chaffed.
5.
Cassette models CAHv contain second cable connection
to control box for infrared unit mount control.
6.
Insure polarized (10 position) connector is in proper
orientation and connected.
7.
Route wires to prevent them from becoming trapped,
cut, broken, or chaffed. See Figure 24.
8.
Tighten fascia up to Cassette chassis. verify a good
seal is obtained between fascia and chassis, necessary
to prevent recirculation.
9.
With filter(s) in place, install inlet grille(s) onto fascia.
figure 22 - Mounting bolts
figure 23 - push In White panel fasteners
figure 24 - Wire Routing
fInAL ASSEMBLY
