© ECS Electronics B.V.
Pag. 12 TO-245-BHU / 190417CD
Option!
P
Info
?
P.D.C.
P.D.C.
PARK DISTANCE CONTROL
PARK DISTANCE CONTROL
Option 1
Option 2
AUTO PARK-SENSOR SWITCH-OFF FUNCTION WITH
THE 5D033 ECU
FUNCTION
INFO
P.D.C.
PDC
Manual
L
Locate the
PDC
(Parking Sensor) Module in the Vehicle.
OPTION 1
When the PDC-system has no specific
MUTE
wire: Locate and cut the wire at
ONE
of the locations A-G and connect to the
ECS
Towbar Wiring Kit
as shown in Option 1. Always check if cutting the wire at the selected location does not create any errors
in the PDC-system or the vehicle, if so, then select another location. In this case the cut wire is connected and the system
operates normally. When the trailer is connected. This wire becomes disconnected by the Trailer Module. If the same module
also controls the Front Sensors then use only locations F or G to prevent the front sensors switching off.
OPTION 2
When the PDC-system has a specific
MUTE
wire: Check in the manual of the PDC-sysctem which input the PDC module requires
to switch off the system (+12v
or
Earth trigger). Then connect the Trigger wire of the PDC system to pin 9 of the ECS connector,
and connect the required feed (+12v
or
Earth) to pin 7 and 5.
Be careful
as connecting the wrong feed can cause damage to the PDC-system.
Always check Before and After installation the PDC System is working correctly, and where possible any error codes
9
5
7
5
7
1 3 5
2 4
R
=
9
5 3 1
7
9
Lorem ipsum
