CO2/CH4 Sampling Data Logger User’s Manual
21 April 2015
PAGE
10
of
19
Optional
Accessories
If the meter is to operate in environments where humidity is very high (>95% RH), an
Extreme
Moisture
Filter
(CM‐0103) can be purchased separately. This filter will allow free flow of sampled
air while keeping moisture out of the meter. A 10,000‐hour pump is also available at the time of
purchase.
Note
: Please contact our technical support staff for more details about these or any other
accessories.
1. GasLab
®
Software section on page 5.
2. Power the meter using the included universal power supply. Turn
ON
the meter.
3. Wait until the display changes colors to visually confirm it has reset successfully after
connecting it to a computer.
Connecting
Meter
The first time the meter is connected to your computer, the operating system will install the
necessary USB drivers as shown in
Figure
4.
This process could take a few minutes.
Figure
4:
USB
Driver
Installation.
Logging
Data
Once the GasLab
®
software has been installed and the meter is connected to the computer, you can
gather data in a variety of ways. Data can be collected in real time, data logs can be downloaded
from the meter’s memory and saved to the computer, and data can be reviewed on the meter’s LCD
display.
For
each
logging
session
1. Turn the meter
ON
by connecting to power supply.
2. The meter must be started at least 1 minute prior to deployment and data logging to allow
the sensor enough time to warm‐up and calibrate.
3. Set the logging interval as desired using GasLab
®
.
4. Turn the Log switch to the
ON
position in order to start the logging session.
5. When data logging is completed, turn the Log switch to the
OFF
position in order to stop the
logging session and disconnect the meter.
