CO2/CH4 Sampling Data Logger User’s Manual
21 April 2015
PAGE
5
of
19
Package
Contents
Please verify that your package contains the following items before using this meter:
UNITS:
(1) Meter
(1) 6‐foot USB cable
(1) International power supply
(1) High‐impact carrying case
(1) Calibration Tag
(1) User manual
(1) Fittings, tubing, & filter kit:
o
(1) 10‐foot long 1/8” tubing
o
(2) 1/8” Barb tubing bulkhead fitting
o
(2) 1/8” Barb 10‐32 UNF fittings
o
(2) Particulate filter (CM‐0118)
o
(2) Hydrophobic filter (CM‐0117)
o
(1) Moisture trap (CM‐0112)
Optional
Accessories
If the meter is to operate in environments where humidity is very high (>95% RH), an
Extreme
Moisture
Filter
(CM‐0103) can be purchased separately. This filter will allow free flow of sampled
air while keeping moisture out of the meter. A 10,000‐hour pump is also available at the time of
purchase.
Note
: Please contact our technical support staff for more details about these or any other
accessories.
GasLab
®
Software
IMPORTANT:
M
AKE
SURE
TO
INSTALL
SOFTWARE
BEFORE
CONNECTING
YOUR
SENSOR
TO
YOUR
COMPUTER
.
Minimum
System
Requirements
To utilize our free software, the computer must meet the following minimum requirements:
1GHz processor with 1GB of RAM, 1GB free disk space (2GB free disk space for 64‐bit
systems).
Windows XP*/7/8/8.1 with Microsoft .NET Framework 4.0** or later.
On Intel‐based Mac computers, GasLab
®
software can run using a Windows 7/8 virtual
machine software such as
VMware
Fusion®
or similar.
*Microsoft .NET is not supported on Media Center or Tablet editions.
**Installer will optionally install .NET Framework.
Figure
1:
Basic
kit
‐
all
units
