background image

Information for DRY use Vacuum cleaners 

24.3

WARNING

Read the instruction manual before using the machine.

Operators shall be adequately instructed on the use of these machines.

As with all electrical equipment, care and attention must be exercised at all times during use, in 

addition to ensuring that routine and preventative maintenance is carried out periodically to ensure safe 

operation.

Failure to carry out maintenance as necessary, including the replacement of parts to the correct standard 

could render this equipment unsafe and the manufacturer can accept no responsibility in this respect.

This machine is for DRY USE only and must not be stored outside or used in wet conditions.

The machine shall be disconnected from the mains by removing the plug from the supply socket during 

cleaning or maintenance and when  replacing parts or converting the machine to another function.

This machine is not to be used by children or persons with reduced physical, sensory or mental 

capabilities, or lack of experience or knowledge. 

Children should be supervised to ensure they do not play with the machine 

This machine is not a toy.

Ensure that the fi ltration system fi tted to the machine is suitable for the material being collected.

CAUTION

This machine is for use indoors only.

This machine should be stored indoors only. 

NOTES

This product complies with the requirements of clause 20 of IEC/EN 60335-2-69 Stability and Mechanical 

Hazards.
This machine is intended for commercial use, for example in hotels, schools, hospitals, 

factories, shops, rental businesses and offi  ces for other than normal housekeeping purposes.

DO

• 

Keep your machine clean.

• 

Keep hoses and tubes clear.

• 

Replace any worn or damaged parts immediately.

• 

Regularly examine the power cord. If damage is found such as cracking or ageing the power cord 

must be replaced by a qualifi ed person using the correct Numatic original part.

• 

Change 908082 H Class Filter Unit with the correct Numatic approved replacement part.

• 

Only use the brushes provided with the machine.  The use of other brushes may impair safety.

• 

Only replace the power cord with the correct Numatic approved replacement part.

DO NOT

• 

Unreel the cable with one pull or pull on the cable to unplug the machine from the power supply.

• 

Use to suck up hot ashes or lighted cigarette ends.

• 

Use steam cleaners or pressure washers to clean the machine or use in the rain.

• 

Immerse in water for cleaning.

• 

Attempt machine maintenance or cleaning unless the power supply plug has been removed from the 

supply outlet.

• 

Under any circumstances place foreign objects including (but not limited to) air fresheners, air 

freshener capsules or scented beads of any type into the top fi lter of the machine. Doing so can be 

dangerous and risk damage to the machine and may invalidate the machine warranty.

Summary of Contents for Numatic HZC 390L-2

















Reviews: