SIMS PRO
84
Calibration Viewer
The calibration viewer allows you to see the calibration details and traces associated with each plate.
To view the calibration trace associated with a plate:
1.
Click
Calibration Viewer
on the home ribbon.
2.
Select a plate on the layout to view its calibration trace.
The calibration tool window opens to the right of the layout window but can be dragged and docked
as required. The view dropdown, at the top of the window, is used to switch between the following
traces:
•
MFLA Top.
•
MFLA Bottom.
•
STARS.
Figure 111: Calibration viewer tool window
Notification Center
The notification center window provides you with additional information on certain actions and can
be useful when an unforeseen event occurs. This window pops up from the bottom of the software
to display the message.
Weld Inspections
The weld inspection tool allows you to mark lines on the layout that have undergone weld inspection
and can either be a straight or a curved line. The location of these can be seen on the report along
with total weld length measurements.
To add a weld inspection:
1.
Click
Weld Inspection
on the home ribbon.
2.
Click on the layout to position the start of the weld inspection.
3.
Click on the layout to position the end of the weld inspection.
Figure 112: Curve weld indication
Summary of Contents for Floormap X
