PERFORMANCE RECOMMENDATIONS
To assure maximum performance, please follow the recommendations below:
1.
For best results, do not locate the heater in an area with a high rate of air movement, as the warm air may be removed from the
area you are intending to heat.
2.
Try placing the heater near a warmer inside wall and direct the output toward a cooler outside wall. The cooler outside wall
will tend to draw the heat toward itself, which will encourage more effi cient heating.
3.
Do not place the heater next to a cold air return, as this will draw the heat away from the area to be heated and prevent effi cient
heating. Experiment with the placement of the heater to see what works best for you.
4.
To ensure maximum effi ciency, a 40% (minimum) relative humidity should be maintained in the heated environment.
5.
The heaters are designed to operate for maximum effi ciency in a room temperature range from 40° to 90° F.
6.
Try lowering your central heating system to a lower temperature and placing the heater in the area you spend the majority of
your time. Now set the heater to your desired comfort level. After all, there is no point in heating multiple rooms when they are
not in use.
7.
When heating larger areas, place the heater in a central location. If a ceiling fan is nearby, try using it at the same time to help
distribute the heat evenly.
FAQs
1. Q: How do I get the fi lter off?
A: See “To Clean the Filter” section of this manual.
2. Q: How do I get the remote cover off?
A: See diagram below.
3. Q: Where do I fi nd the serial number?
A: On the back of the heater, there is a large, black, rectangular sticker. Toward the middle of the
sticker is the serial number.
4. Q: What does the red light that comes on when I plug the unit in mean?
A: The light simply indicates that the unit is plugged in, the master power switch is in the on position
and that it can be turned on for use at any time.
2. With the tab
pushed toward the
right, slide the lip
of the battery tray
toward you.
1. Push the far
tab on bottom,
left-hand side of
the back of the
remote toward
the right.
PARTS AND FEATURES
NOT RECOMMENDED FOR
Basements • Garages • Sheds • Rooms with Vaulted Ceilings • Construction Sites
Outdoor Areas • Any Non-Insulated Area
READ ALL INSTRUCTIONS BEFORE USING THE HEATER
1.
We recommend keeping the packaging for off-season storage and for any transportation needs.
2.
Find a level and unobstructed location to place the unpackaged heater.
3.
Do not plug in or run any appliances on the same circuit that the heater is on.
4.
Plug the power cord directly into an unused, grounded outlet.
Used to turn power to the unit on and off.
Used to turn the heater on and off. This will only work if the master power switch (shown above) is on.
Used to increase the desired temperature.
Used to decrease the desired temperature.
Used to switch between LOW and HIGH modes.
a. LOW MODE: In low mode, the heater runs on a lower wattage in order to use less electricity.
Running the heater in low mode can sometimes be more benefi cial in smaller rooms where less heat is necessary.
b. HIGH MODE: In high mode, the heater consumes more wattage but also produces more heat.
High mode is recommended for larger rooms that are harder to keep warm.
IMPORTANT: To turn the heater off, press the “POWER” button; the fan will continue to run
until all of the heat has been expelled. This could take up to 3 minutes in some cases.
DO NOT UNPLUG WHILE RUNNING.
WASHABLE LIFETIME FILTER SYSTEM
Classic CopperPLUS
TM
heaters come with a washable lifetime fi lter that is easy to clean.
IMPORTANT INFORMATION: If you have allergies and/or are sensitive to dust, you will want to use this fi lter. When choosing to use the
fi lter, it must be cleaned as often as necessary; a clogged fi lter will prevent the heater from working to its fullest capacity. If the heater
is used in an extremely dirty or dusty area, the fi lter must be cleaned more frequently to keep it from clogging.
To clean the fi lter:
1. Release the fi lter. (See pictures)
2. Run warm tap-water over the fi lter in the opposite direction of air fl ow, until the water runs clear.
The fi lter might excrete some fi ltered residue so be cautious not to drip on any stainable surfaces such as carpeting. You can
also soak the fi lter in water mixed with a small amount of mild dish soap.
3. Shake the fi lter over a sink until excess water is removed and allow it to air dry completely before reinstalling.
DO NOT force the fi lter to dry using any alternative methods.
4. Reinstall the fi lter to the rear of the unit by positioning the fi lter back in place and securing the fi lter back into the locked position.
1. Place your
fi ngers on the
bottom of the
fi lter and press
upward to
release the fi lter
from resting on
the two tabs.
2. With the fi lter
lifted off of
the tabs, pull it
toward you to
release it.
WARNING
IMPROPER USE OF THIS HEATER COULD RESULT IN RISK OF FIRE, ELECTRIC SHOCK,
AND INJURY TO PERSONS
WARNING
ANY REQUIRED SERVICE, OTHER THAN FILTER MAINTENANCE, SHOULD BE PERFORMED
ONLY BY AN AUTHORIZED SERVICE REPRESENTATIVE. ANY OTHER REPAIRS ATTEMPTED BY ANYONE
OTHER THAN AN AUTHORIZED SERVICE REPRESENTATIVE WILL VOID THE WARRANTY.
FOR AUTHORIZED SERVICE, CALL 1-800-225-6595 OR VISIT WWW.EDENPURESERVICE.COM.
WARNING
RISK OF ELECTRICAL SHOCK. DO NOT OPEN.
NO USER-SERVICEABLE PARTS INSIDE.
1. READ ALL SAFETY INSTRUCTIONS BEFORE USING THE HEATER
2.
This heater’s grill is hot when in use. To avoid burns do not let bare skin touch hot surfaces. Keep combustible materials such as furniture, pillows,
bedding, papers, clothes and curtains at least 3 feet (0.9m) from the front, sides and rear of the heater.
3.
Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.
4.
Always unplug heater when not in use.
5.
Do not operate any heater with a damaged cord or plug, or after it has been dropped or damaged in any manner. In such cases, return the heater
to an authorized service facility for inspection/repair.
6.
Do not use the heater outdoors or on construction sites.
7.
The heater is not intended for use in bathrooms, laundry areas and similar indoor locations, areas with standing water, a shower or swimming pool.
Never place the heater where it may fall into a bathtub or other water container.
8.
Do not run the cord under carpeting. Do not cover the cord with throw rugs, runners, or similar coverings. Arrange the cord away from traffi c
areas and where it will be tripped over.
9.
To disconnect the heater, turn the unit off, then remove the plug from the outlet once the fan has stopped running.
10.
Manual restart maybe required if power to this unit is interrupted.
11.
Do not insert or allow foreign objects to enter any ventilation or exhaust opening, as this may cause an electric shock or fi re, or damage the heater.
12.
To prevent a possible fi re, do not block or place anything in the front or rear of the heater.
13.
When performing fi lter maintenance, do not force the fi lter to dry using alternative methods. Doing so could damage the fi lter.
14.
A heater has hot and arcing or sparking parts inside. Do not use in areas where gasoline, paint, or fl ammable liquids are used or stored.
15.
This product contains a button battery. If swallowed, it could cause severe injury or death in just 2 hours. Seek medical attention immediately.
16.
Use this heater only as described in the manual. Any other use not recommended by the manufacturer may cause fi re, electric shock or injury to
persons and may void the warranty.
17.
Do not plug the heater into any other cord-connected device such as a power strip, surge protector, multiple outlet adapter, grounding adapter
or outlet-type air fresheners. Plug into a 3-prong 120v 15amp or higher grounded circuit receptacle only. Do not plug the heater into a loose-
fi tting or broken receptacle. This heater is for use on 120 volts.
18. SAVE THESE INSTRUCTIONS.
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic precautions should always be followed to
reduce the risk of fi re, electric shock and injury to persons, including the following:
5. Q: Can I move the heater around while it’s running?
A: No. It is not recommended to move any portable heater when it is operating. We recommended moving the heater only after
it has been powered off and the fan has completely stopped.
6. Q: What is the life expectancy of the PTC heating element?
A: The average life span of a PTC heating element is up to 80,000 hours. To replace a heating element, please call Customer Service
at 1-800-225-6595 or visit www.edenpureservice.com.
7. Q: Can I use the heater and other appliances at the same time?
A: Yes, as long as they are not running off of the same circuit. Zone heaters are considered an appliance and you should never run
more than one appliance on a single circuit breaker. Your freezer, refrigerator, microwave, washing machine, dryer, heaters and
other such appliances should not share a circuit breaker.
8. Q: Can I use an extension cord, surge protector, power strip or cord adapter with my heater?
A: No. It must be plugged directly into a grounded outlet. If you don’t have a grounded outlet, contact a licensed electrician to
have one installed. Removing the grounding plug or altering any part of the unit will void the warranty.
Classic CopperPLUS
TM
A5946
I-5619 BR11884R-1.indd 2
8/15/19 2:42 PM
