background image

READ ALL INSTRUCTIONS BEFORE USING THE HEATER

1) This heater is hot when in use.  To avoid burns do not let bare skin touch hot surfaces.  Keep combustible materials such as furniture, pillows, bedding, papers, clothes

and curtains at least 3 feet (0.9m) from the front of the heater and keep them away from the sides and the rear.

2) Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left operating and unattended.

3) Always unplug heater when not in use.

4) Do not operate any heater with a damaged cord or plug, or after the heater malfunctions, has been dropped or has been damaged in any manner.  In these cases,

return the heater to an authorized service facility for examination, electrical or mechanical adjustment, or repair.

5) Do not use the heater outdoors or on construction sites.

6) The heater is not intended for use in bathrooms, laundry areas and similar indoor locations, areas with standing water, a shower or swimming pool.  Never place

the heater where it may fall into a bathtub or other water container.

7) Do not run the cord under carpeting.  Do not cover the cord with throw rugs, runners, or similar coverings.  Arrange the cord away from traffic areas and where it

will not be tripped over.

8) To disconnect the heater, turn the unit off, then remove the plug from the outlet once it has stopped running.

9) Do not plug the heater into any other cord connected device such

as a power strip, surge protector, multiple outlet adapter, ground-
ing adapter or outlet-type air fresheners.  

Plug into a 3-prong

110v 15amp or higher grounded circuit receptacle only.

10) Do not insert or allow foreign objects to enter any ventilation or ex-

haust opening as this may cause an electric shock or fire, or dam-
age the heater.

11) To prevent a possible fire, do not block air intakes or exhaust in

any manner.  Do not use on soft surfaces, like a bed, where open-
ings may become blocked.

12) Do not block the front or rear of the heater.

13) Do not place anything directly in front of the heater.

14) When performing filter maintenance, do not force the filter to dry

using alternative methods. Doing so could damage the filter.

15) A heater has hot or arcing or sparking parts inside. Do not use in

areas  where  gasoline,  paint  or  flammable  liquids  are  used  or
stored.   

16) Do not plug the heater into a loose-fitting or broken receptacle.

17) Do not alter the heater’s design or you will void the warranty.

18)   In the event that you open the cabinet of the heater, do not touch the heating elements with your bare hands.  Moisture, oils or residue from the skin can weaken

the glass and shorten the life span of the element.

19) The heater must be located immediately in front of a socket outlet.

20) Always plug heaters directly into a wall outlet/receptacle. Never use with an extension cord or power tab/power strip.

21) The heater is for use on 110 volt outlets. The cord has a plug as shown at “A” in Figure above. An adapter as shown at “B” is available at your local hardware store

for connecting three-blade grounding type plugs to two-slot receptacles. The green grounding plug extending from the adapter must be connected to a permanent
ground such as properly grounded outlet box. The adapter should not be used if a three-slot grounded receptacle is available. Figure “C” European type plug.

22)  Some EdenPURE

®

heaters contain a button battery for the remote. If swallowed, it could cause severe injury or death in just two hours. Seek medical attention

immediately.

23)  Use this heater only as described in the manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons and may

void the warranty.

24)  Manual restart is required if power to the unit is interrupted.

GROUNDING

PIN

GROUNDING

PIN

GROUNDING

MEANS

COVER OF GROUNDED

OUTLET BOX

ADAPTER

(B)

(C)

(A)

METAL SCREW

WARNING: In order to avoid overheating, do not cover the heater.

WARNING

IMPROPER USE OF THIS HEATER COULD RESULT IN RISK OF FIRE, ELECTRIC SHOCK, 

AND INJURY TO PERSONS

WARNING

ANY REQUIRED SERVICE OTHER THAN FILTER MAINTENANCE SHOULD ONLY BE 

PERFORMED BY AN AUTHORIZED SERVICE REPRESENTATIVE AND ANY 

OTHER REPAIRS ATTEMPTED BY ANYONE 

OTHER THAN AN AUTHORIZED SERVICE 

REPRESENTATIVE WILL VOID THE WARRANTY

CAUTION

RISK OF ELECTRICAL SHOCK

DO NOT OPEN

NO USER-SERVICEABLE PARTS INSIDE

Summary of Contents for Quartz Infrared Portable Heater

Page 1: ...To ensure you get the best results from your portable heater please read this manual first and keep it for future reference For additional information please contact your place of purchase or call 1 800 219 8458 Thank you for purchasing an EdenPURE Quartz Infrared Portable Heater ...

Page 2: ... maintenance do not force the filter to dry using alternative methods Doing so could damage the filter 15 A heater has hot or arcing or sparking parts inside Do not use in areas where gasoline paint or flammable liquids are used or stored 16 Do not plug the heater into a loose fitting or broken receptacle 17 Do not alter the heater s design or you will void the warranty 18 In the event that you op...

Page 3: ...t and use your heater without it To clean the filter 1 Press the tab s on the top of the filter cover to release the filter 2 Run warm tap water over the filter the opposite direction of air flow until water runs clear The filter might excrete some filtered residue so be cautious not to drip on any stainable surfaces such as carpeting You can also soak the filter in water mixed with a small amount...

Page 4: ...ircuit Can I use the heater on a job construction site The heater was not designed to be used in a high dust construction environment Using the heater for this purpose will void your warranty Can I move the heater around while it is operating It is not recommended to move any portable heater while it is operating We recommend moving the heater only after the fan has completely turned off What is t...

Reviews: