31
Eder Forestrytools
310003_04 | 06.2019
All 4 knives are exchanged and adjusted in the same way. Proceed
as follows for each knife:
Fig. 14:
Changing the knives
> Loosen the knife screw (
1
- Fig.10) on the milling head (
3
-
Fig.10) with a 6 mm Allen key.
> Replace the circular knives (
2
- Fig.10) or turn the circular knives
by 180°.
> Retighten the knife screw. Tightening torque: 35 Nm.
Setting the guide block on the EDER Trough Cutter
Set ETH-A56
The position of the guide block determines the depth of the cavities.
> Clamp the tip of the guide block on the lower side between the
protective plates.
> Slide the guide block between the protective plates in longitudinal
direction as required:
•
For deep cavities, move it far forward.
•
For shallow cavities move it far back.
> Make sure that the guide block does not touch the rotating
knives.
1
2
3
