Adjusting the Knives on the EDER bark - stripper
For optimal performance of the bark - stripper, sharp, correctly adjusted knives
are required.
For adjusting, you need the provided hexagonal wrench and proceed as
follows:
1. Lay wrench onto the device as in illustration below.
2. Make wrench and hard metal pin touch each other.
3. Hold wrench in this position, now turn back the peeling barrel, until the
knives stand in front of the wrench (viz. illustration)
4. Adjust distance to 0.5 to 1.5 mm.
5. All 4 knives are adjusted in the same way.
6. The clamping bolts for the knives are to be tightened at a torque of at least
35 Nm. A corresponding torque wrench can be obtained from EDER-
Maschinenbau as optional accessory or from the specialized tool trade.
7. The knives may never be positioned beyond the hard metal pins, as the
hard metal pins serve as depth limitation.
8. It’s absolutely necessary, that the hard metal pins show forward in direction
to the knife edge.
