19
1.-INSTALLATION
Positioning and levelling
The positioning and electrical and gas installation should always be carried out by an AUTHORISED TECHNICIAN,
observing the standards of each country.
It is advisable to install an extraction hood for the optimum operation of the appliance.
Place the appliance in a well ventilated place.
Level and adjust the height of the appliance. (Fig. 5)
IMPORTANT:
unless otherwise indicated, parts which have been protected by the manufacturer should not be handled
by the installed
.
Electrical connection
An AUTHORISED TECHNICIAN should always carry out the appliance’s electrical connection.
The legal standards in force in each country on connections to the mains should be taken into account.
Check that the mains voltage corresponds to that indicated on the nameplate.
Use cable sleeves made out of polychloroprene or other similar materials (H05RN-F), for the connection.
Put an autonomous power switch with fuses into the mains socket, with a minimum distance between contacts of at least
3 mm.
It is obligatory to earth the appliance. The manufacturer takes no responsibility if this requirement is not fulfilled.
The section of cable sleeve and the rating of the fuses to be installed in the power switch are indicated in table no
2
Route the cable through the stuffing box indicated in point E (Fig. 1) and connect it to the terminal strip.
VERY IMPORTANT
: When several appliances are installed in series, they should be earthed to each other using the
point assigned for this purpose, located in the rear part of the appliance.
2.-USE
Turning the appliance on
After installing the appliance, it is necessary to fill it up with water with detergent, which is left to boil for a few minutes.
Next, empty the tub and rinse it as many times as necessary, to eliminate the remains of soap.
Turning the resistors on and off
a) Activate the power switch.
b) Turn the regulator control clockwise until the pilot light 3 lights (Fig. 3) The machine is connected, 1 (Fig. 4)
c) Turn the regulator control clockwise to the desired position, 2 (Fig. 4) (TABLE 2). Pilot light 2 lights up (Fig. 3).
d) To turn the resistors off, turn the thermostat control anticlockwise to the OFF position, 0 (
Ɣ
) (Fig. 4)
