E
N
G
L
IS
H
40
If you wish, you can wash only half the full dishwasher load (=6 place services). To do
this: 1) Choose the programme, as shown in the corresponding boxes; 2) press the 1/2
button, and
3) place the dishes in the upper basket.
The amount of detergent you should
add is 15 + 5 grs. for the Intensive Programme and 15 grs. for all other programmes.
NOTE:
In type A models, while washing is in progress, pilot lights , which correspond to the
optional function buttons selected , light up, and in type B models the pilot light ,
which correspond to the optional funcion buttons , light up.
Half Load
E
N
G
L
IS
H
IMPORTANT:
If the problem persists, make a note of it (as shown in the Table) and contact the
TECHNICAL
ASSISTANCE SERVICE
TROUBLESHOOTING
11
12
17
16
Door open
PROBLEM
Water not entering
Doesn’t drain
Overflows
Overheats
Does not heat up
Temperature Sensor
-Intermittent
-Off
PHASE PILOT LIGHT (type A)
Lack of water pressure
Nº BEEPS
END LED
(ST
OP)
FUNCTIONING LED
PHASE PILOT LIGHT (type A y B)
NOTE:
If in type A models, you see that any of the phase pilot lights are flashing
or in type B models, that pilot light or is flashing, press the Start/Pause button
,and it will emit the same number of beeps as the number of the problem. Beep
detection can be repeated as often as you wish.
10
13
DISPLA
Y (onl
y delux
e
mod
el) (
type A y B)
F1
F2
F3
F4
F5
F6
F7
F8
PR
EW
ASH
W
ASH
DR
Y
END
MODEL
DISPLAY
1
2
3
4
5
6
7
8
14
15
This table is also shown on the upper door rim (it can be seen by partly opening the
dishwasher door).
28
If a failure occurs in your dishwasher, you will hear a continuous warning beep and the
problem type will light up on the display at the same time (F1,F2,F3...F8).
Here is a troubleshooting table: The problems detailed in the table will depend on the model
of dishwasher.
If you have any of the problems shown in this table, first check that the dishes are placed
correctly and restart the programme as described in section 2 above (Programme selection)
1/2
