Quick Installation Guide
ECW5211-L
ENGLISH
⑬
Step 3. Configure General Wireless Settings
Under Home > Wireless > General, there are global settings for RF Card A and B. RF Card A is operating in
2.4 GHz band and RF Card B is operating in 5 GHz band, both of which are enabled by default.
For initial configuration, you might want to change the default basic settings shown below:
RF Card A
– 2.4 GHZ, 802.11g+802.11n, Antenna Mode 2T2R, Channel Width 40 MHz, Channel 6
RF Card B
– 5 GHz, 802.11ac, Antenna Mode 2T2R, Channel Width 80 MHz, Channel 36
You can make changes to other settings at a later time.
Well done!
After a system restart, the AP should be able to operate with these settings.
Note:
- VLAN ID is supported only when the VAP is in Bridge mode.
- DHCP Profile and DHCP Server are activated only when the VAP is set to NAT mode.
- If the VAP is in NAT mode, the CAPWAP Tunnel Interface will only work in two states:
Disable
(No Tunnel) or
Split Tunnel
.