Quick Start Guide
–
2
–
Connect Network Cables
1.
For the RJ-45 ports, connect Category 5e or better twisted-pair
cable.
2.
First install SFP/SFP+ transceivers and then connect fiber optic
cabling to the transceiver ports.
The following transceivers are supported in the SFP+ ports:
10GBASE-SR
1000BASE-SX
3.
As connections are made, check the port status LEDs to be sure
the links are valid.
Make Initial Configuration Changes
1.
Connect a PC to one of the SD-WAN Edge CPE’s LAN ports.
2.
Log in to the web interface using the default management IP
address 192.168.100.1 (there is no user name or password).
3.
Configure the Barrista controller IP address and port through
one of the following methods.
DHCP: Automatic configuration.
Static: Manually set the IP address, subnet mask, default
gateway, and DNS servers.
PPPoE: Set the PPPoE username and password.
Click “Save” to confirm the configuration and enable the SD-WAN
Edge CPE to communicate with the Barrista controller.
Hardware Specifications
5
1
2
6
Form Factor
1 RU rackmount
Dimensions
(W x D x H):
442 x 298.3 x 43.6 mm (17.4 x 11.74 x 1.72 in.)
Weight
4.43 kg (9.77 lb), with two installed PSUs
CPUs
CPU Intel® Atom™ Processor C3758 SoC (14nm)
2.2 GHz
Support 8 cores
Memory
Sockets: 2x260pin DDR4 SODIMM slots
Type: 2 x 8GB DDR4-2400 ECC DRAM (32GB max)
Local Storage 1 x M.2 SATA 3 SSD, 128GB
I/O Interfaces 1 x USB 3.0 Type A
1 x RJ-45 serial console
Network
Interfaces
4 SFP+ 10GbE ports
8 RJ-45 GbE ports
Expansion
Type: Internal Mini PCIe slots x2
Accelerator
Advanced Technologies: Intel QuickAssist, VT-x, VT-
d, EPT, AES-NI
Storage Encryption: TPM V2.0
Power Supply
Unit Rating
Input: AC 100V to 240V @ 50-60 Hz
Type: 300 W
System
Cooling
Two active fans in rear, support smart fan speed
control
Temperature
Operating: 0 °C to 45 °C (32 °F to 113 °F)
Storage: -40 °C to 70 °C (-40 °F to 158 °F)
Humidity
Operating: 5% to 95% (non-condensing)
Storage: 5% to 90% (non-condensing)
Compliances CE
FCC
CB
UL/cUL
RoHS 2.0
