9. Installation and Configuration
After preparing the information you need as specified in section 5, follow the following steps to do
the basic configuration. You can use either a telephone or a system console to perform basic
configurations. It is simple to connect a telephone set to FXS port and configures the system. If you
want to use system console to configure the system (Only VG3306/3310/3318 support), you have to
configure your VT100 terminal to match the settings of the gateway’s console port. The console
port’s terminal connection is set to 9600 baud, 8 data bits, 1 stop bit and no parity. Turn on the
gateway’s power and wait for the terminal to display “Press Enter…” follow the directions to begin.
Here are several procedures to do:
1. Confirming the Region ID.
2. Configure IP address of gateway.
3. Enter into the WEB page.
4. Plan and configure the channels into SIP entity.
5. Configure SIP proxy and register information.
6. Configure SIP entity information.
7. Configure Outbound Authentication (If needs).
8. Configure STUN (If your gateway is behind NAT).
9. Check the SIP entity if is registered successful.
10. Configure Phone book (If needs)
11. Make a SIP call.
9.1. Confirming the Region ID
About the Region ID, please refer to Section 15.5 Region ID.
9.1.1. Phone
Setting
1. Connect the power.
2. Connect the phone cable to the “Phone” socket on the rear panel as pictured above.
3. When the CPU/ACT LED is on, pick up the handset and listen for the dialing tone.
4. Dial “##0000” and listen for 3 short beep.
5. Dial “9507#”
;
Assuming you are modifying for China (The last 2 digits are the regional ID)
6. Dial “971#”
;
Sets the new regional ID.
7. Hang up the phone. The device will be updated with the new region setting after it restarts
(restart time is about 10 seconds)
12
Summary of Contents for SIP Gateway VG3300 Series
