6
3. Then open the thickness control plate fully to its maximum open position as
shown in Figure 5. While still holding the face of the sharpener against the
push bar, slide the sharpener left along the push bar until its end face contacts
and aligns with and against the thickness control plate as shown. The power
remains “OFF.”
4. Carefully advance the carriage as shown in Figure 6 toward the slicer blade
with your four fingers securely positioned in the fingers pocket and your thumb
behind the push bar as shown. Hold the sharpener against the push bar and
simultaneously against the thickness control plate. The sharpening disk should
now be positioned behind the slicer blade as shown in Figure 6 but not yet in
contact with the blade.
Figure 6. M ove food
carriage forw ard to
position sharpening disk
behind the slicer blade
as show n.
Figure 5. Slide blade
sharpener against
thickness control plate
(show n fully open).