3
Warning: Use two or more people to move and install the kegerator. Failure to do so can
result in back or other injury. Carefully remove the packaging materials. Remove any
shipping tape and glue from your kegerator before using. Do not use sharp instruments,
rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your kegerator.
z
Important: Do not remove any safety, warning, or product information labels from your
kegerator.
Note: This appliance is designed for indoor use only and should not be used outdoors.
Installation Location
To ensure the kegerator will last, install it in a location where there is proper air circulation and
electrical connections.
Keep the kegerator away from heat and direct sunlight.
This kegerator is
designed for indoor use only and should not be used outdoors. It should not be placed in a built-
in or recessed area as it is designed to be a freestanding kegerator.
Allow at least 2” to 3” of
clearance at the sides of the kegerator, and 4” to 5” of clearance at the back.
Unpacking the Kegerator
Installing the Kegerator
The kegerator should be installed in accordance with local electrical code requirements. The
kegerator should also be placed in a location that is strong enough to support its total weight,
keeping in mind that it will weigh substantially more when fully loaded than when empty.
Before you plug the kegerator into a power supply, be sure to let it stand upright for at least 24
hours to allow the compressor’s oils to settle.
Freestanding Installation:
A freestanding installation will allow you to install the beverage refrigerator in almost any
place you desire as long as there is proper ventilation. This product is not designed to be
built into a cabinet or recessed setting. You must follow the stated instructions for electrical
requirements and leveling the beverage refrigerator.
•
Choose a location that has ambient temperatures above 50° F and below 90° F.
Operation outside these temperatures may lead to lowered efficiency or other adverse
effects.
•
This unit MUST be installed in an area protected from the elements, e.g., wind, rain,
water spray or drips.
•
The beverage refrigerator should not be located next to ovens, grills, or other high heat
sources.
Summary of Contents for BR1000SS
Page 5: ......
