12
Built-in Installation
A built-in installation allows the kegerator to be placed under counter. This installation requires
several more steps and considerations than a free standing installation.
Countertop Opening for Dispense Kit
Once the location of the kegerator installation is determined the first step is to create an
opening in the counter for the dispense kit lines to pass through. Mark off a spot on the
countertop where the opening will be created. Align that spot so it will be directly above the
opening of the kegerator that will be placed under the counter. You will need to drill or cut
(depending on the material of your countertop) an opening into your counter the same size
as the opening of the top of the kegerator. Do not cut it larger than that size as the
dispense tower will be optimized for that size hole.
Note: Please refer to the dispense kit installation guide to complete the full assembly of the
kegerator.
Important Notes:
Choose a location that has ambient temperatures above 50°F and below 95°F. Operation
outside these temperatures may result in lowered efficiency or cause other adverse
effects.
This unit MUST be installed in an area protected from the elements, e.g., wind, rain, water
spray, or drips.
The kegerator should not be located next to ovens, grills, or other high heat sources.
Do not kink or pinch the power supply cord between the kegerator and the wall or cabinet.
