16
Caution: If you power off the unit, please wait at least 5 minutes before powering it back on.
Note: Whether your kegerator can reach the actual set temperature depends on the ambient
environmental conditions.
Operation
Installation Check List Before Operation
1. Have all packing materials and tape been removed from the interior and exterior of the
kegerator?
2. Have the installation instructions been followed, including connecting the machine to electricity?
And has proper grounding been installed for the kegerator?
3. Has the machine been leveled?
4. Is the kegerator in a site where the ambient temperature is between 50ºF and 95ºF all
year round?
Using the Temperature Control Panels
Use the up and down buttons to adjust the temperature. The temperature displayed can be in
Fahrenheit or Celsius. This kegerator has a temperature range from 32°F to 60°F.
This kegerator has one display. The unit will display the set temperature only. The kegerator also
has a memory function that allows the unit to revert back to the most recent set temperature in
the event of a power outage, or if the unit is manually powered off and back on.
Press the
button on the control panel to lower the temperature by a 1 degree increments.
Press the
button on the control panel to increase the temperature by a 1 degree increments.
Press the
button to turn the inner light on or off.
Press and hold the power button for approximately three (3) seconds to turn the unit’s power on
or off. The Run Light will illuminate when the unit is working.
The Celsius or Fahrenheit light will be lit depending on what scale temperature is being
displayed. To switch between C and F, press and hold the and buttons at the same time for
approximately five (5) seconds until the temperature scale changes.
