12
Operation
Installation Checklist before Operation
Using the Temperature Control Panel
1. Have all packing materials and tape been removed from the interior and exterior of the refrigerator?
2. Have the installation instructions been followed, including connecting the machine to electricity?
And has proper grounding been installed for the refrigerator?
3. Has the machine been leveled?
4. Is the refrigerator in a site where the ambient temperature is between 50° F and 90° F all year
round?
5. Is there a clearance of at least 1- 2” at the rear, 1/4” at the top, and 1/4” at the sides for proper air
circulation?
This refrigerator has two cooling zones that are controlled independently by two separate control panels,
one for the left side zone and one for the right side zone. The refrigerator has a temperature range from
40° F to 65° F. The control panel in each zone will display the set temperature inside the cabinet.
Power Button:
Press and hold for approximately 3 seconds to turn the unit on or off.
Up Button:
Press to increase the temperature by 1 degree increments.
Down Button:
Press to decrease the tempreature by 1 degree increments.
Light Button:
Press the button to turn the inner light on or off.
F
Run Light:
When lit, the unit is in cooling mode.
i
Celsius/Fahrenheit Light:
The Celcius or Fahrenheit light will be lit depending on which
temperature type is being displayed. To switch between C and F press and hold both the
Up and Down buttons simultaneously for approximately 3 seconds. A beep will occur and
the indicator light will illuminate next to desired temperature setting.
i
