5
Electrical System
EdgeWater 200CC / DC
23
5.1 General
Your EdgeWater 200CC / DC operates on a 12 volt DC system, similar to your automobile. The
battery or batteries are typically lead acid type and require similar maintenance to your car’s battery. An
electrical schematic is included in the appendix for specific location of electrical components.
5.2 Accessory Panel Switches
Your EdgeWater 200CC / DC is equipped with panel breakers. One switch
is for the running/anchor lights, one for the optional livewell, one for an
optional washdown system, and one to activate the bilge pump manually.
The 200DC has an additional switch for accessories and the 200CC has
three additional switches for the owner to use other accessories. In
addition, there is a cigarette lighter type plug to provide for plug-in accessories. A wiring diagram is
included with this manual to assist you in troubleshooting the boat’s electrical system. Please note that
the accessory circuits are each protected by a 20 amp breaker. Check the requirement of any device
you install and change the breaker to the required capacity if necessary.
There is a battery selector switch which provides isolation for each battery and also provides the ability
to have a back-up in case of a dead or weak battery. When in port and running accessories such as
entertainment equipment or pumps, the selector switch should be set on “1” or “2”. When leaving the
boat unattended, the selector switch should be in the “OFF” position.
Current is supplied to the automatic float switch and the bilge pump even when the battery selector
switch is in the “OFF” position.
Do not switch the battery position if the engine is running, as damage to the engine’s electri-
cal system may occur.
5.3 Electrical System Maintenance
At the beginning and end of each season the exposed electrical components of the switch panel should be
sprayed with a non-conductive rust/corrosion inhibiting spray. Light bulb connections and running light
connections should be covered with a non-water soluble lubricant. Care must be taken not to get grease
on the glass portion of the lights as it will cause them to overheat and burn out. Inspect all wiring for
breaks, loose terminals and sound insulation. Replace worn or deteriorated components. Check the
electrolyte level in the batteries regularly and fill with distilled water, as necessary. DO NO
DO NO
DO NO
DO NO
DO NOT O
T O
T O
T O
T OVERFILL.
VERFILL.
VERFILL.
VERFILL.
VERFILL.
“2” Position
“OFF” Position
