3
Inserting Battery
Attention! Insert the battery as it is shown in the
picture (“plus” to the front side of the recorder).
Otherwise, the recorder could be harmed.
After you inserted the battery, keep the control
button pressed for two seconds. The LED has
to flash three times (if that does not happen, the
battery is discharged or malfunctioning) showing
that the recorder is self testing. After 5-10 seconds,
the recorder’s LED signals the fourth time: it means
that the recorder is ready for work. The duration
of the fourth flash can be some dozen seconds
(depending on the recorder’s memory capacity).
To evaluate the recorder’s recording time in
different operating modes, use the table data.
Recorder
Battery
Lid of the battery
compartment
Figure 2: Inserting battery
