Page 7
Specifications
Power output: RMS 6W
×
2 (THD+N=10%, f
0
=1KHz, DRC off)
Signal to noise ratio: ≥80 dBA
Distortion: ≤ 0.5% (@½ output)
Frequency response: 200Hz~20KHz (@+/-6db)
Input type: AUX/iPod/iPhone/Bluetooth
Input sensitivity: iPod: 800 mV ± 50mV (THD+N=1%)
Adjustment: Buttons on the top of speaker, remote control
Speaker unit: 2¾ inch (70mm), magnetically shielded, 8ohm
Dimension: 300(W) × 90(H) × 133(D) mm
Net Weight: Approx. kg
Gross Weight: Approx. kg
Page 8
Trouble shooting
Not all speakers function:
Please first check if the speaker wires are connected securely; then check if the Line-in connectors are
reversed; check also if the audio source is at fault.
One satellite speaker does not function when playing CD from computer:
This kind of phenomena is prone to happen on new computer systems that one satellite does not function
when playing CD, but system works fine when playing WAV formatted files. This is mainly due to the fault connection
of CD-ROM and sound card, that one channel of signal is shorted to the ground. Please refer to the manual of
CD-ROM and sound card to adjust the wire connection.
System does not work at all:
1. Please check if power is connected, and if the wall outlet is switched on.
2. Please check if the amplifier is still in STBY mode.
3. Please check if the master volume is turned to minimum.
4. Please check if the audio input cable is connected correctly.
5. Please check if there is signal from audio source.
Noise coming from speakers:
Amplifier circuitry of this product generates little noise, while the background noise of some VCD/DVD player
or computer sound card are too high. Please keep the system in active mode and remove the audio source, if no
Battery loading
: Please refer to the illustration on the right side to open the battery
compartment, insert the included AA size, CR 2025 battery and close the compartment.
Note
:
Do not place the remote control in places that are hot and humid.
Remove the batteries when unused for long period of time.
The battery (battery or batteries or battery pack) should not be exposed to excessive
heat such as direct sun, fire or similar.
