55
Enable wireless access control Enable wireless access control
Add MAC address into the list Fill in the "MAC Address" and
"Comment" of the wireless station to be
added and then click "Add". Then this
wireless station will be added into the
"Current Access Control List" below. If
you find any issues before adding it and
want to retype again. Just click "Clear"
and both "MAC Address" and
"Comment" fields will be cleared.
Remove MAC address from list If you want to remove some MAC
address from the "Current Access
Control List ", select the MAC
addresses you want to remove in the
list and then click "Delete Selected". If
you want remove all MAC addresses
from the table, just click "Delete All"
button. Click "Reset" will clear your
current selections.
Click <
Apply>
at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start
using the router (with the advance settings in place)
2.5 QoS
The QoS can let you classify Internet application traffic by
source/destination IP address and port number. You can assign priority for
each type of application and reserve bandwidth for it. The packets of
applications with higher priority will always go first. Lower priority
applications will get bandwidth after higher priority applications get enough
bandwidth. This can let you have a better experience in using critical real
time services like Internet phone, video conference …etc. All the
applications not specified by you are classified as rule name “Others”. The
rule with smaller priority number has higher priority; the rule with larger
priority number has lower priority. You can adjust the priority of the rules by
moving them up or down.
