Introduction
Wireless Gaming Adapter’s connection ports are located on the back panel. Below is
the description of each connection port.
y
Antenna Connector
This round connection is standard Reverse SMA connector where any antennas
with Reverse SMA connector can connect to the Access Point.
y
DC Adapter Port
Insert the power jack of the power adapter into this port.
y
Console Port
The Wireless Gaming Adapter’s console port is where you connect to your game
console or other device with wired Ethernet.
y
Head 2 Head / Infrastructure button
Press this button once and the Wireless Gaming Adapter will switch from “Head
to Head mode” to “Infrastructure mode” if it is currently in “Head to Head mode”
or will switch from “Infrastructure mode” to “Head to Head mode” if it is
currently in “Infrastructure mode”.
y
Reset
The Reset button allows you to do one of two things.
1)
If problems occur with your Wireless Gaming Adapter, press the reset
button with a pencil tip (for less than 4 seconds) and the Wireless Gaming
Adapter will re-boot itself, keeping your original configurations.
4
