2
English
*Driver for Windows 98SE/Me/2000/XP:
I. Install the Hardware
Note.
This step is for EW-7628Ig PC I card only, if you are going
to setting EW-7608Pg Cardbus, please
j
ump to chapter II.
directly a nd
do not install the adaptor into your computer
before installing the software program from the CD.
Installation Procedure
1. Turn off your computer and remo ve its cover.
2. Insert the PC I card to an a vailable PCI slot firmly.
3. Secure this card to the rear of the comp uter chassis a nd put
back the cover.
4. Secure the a ntenna to the antenna connector of the card.
5. Turn o n the computer.
Guidelines for the Hardware Installa tion
Please observe the following guidelines when you are installing
the PCI card to the Desktop PC:
Avoid placing the PC close to obstacles
Obstructions such as concrete walls and thick me tals limit radio
signal pe netration and reduce the throughp ut and the co verage
range of the PC I card and Place the PC as high as possible
The higher the PC is placed, the better the performance.
Adjust the antenna position
The card has two antennas for signal reception and one a ntenna
for high power signal transmission. The antennas on the right
and left side are for sig nal reception and should be set
perpendicular (90 degrees) to each o ther. The central one is for
signal tra nsmission and should be p ulled up about 45 degree.
Please refer to the illustration below:
Summary of Contents for EW-7608Pg
