121
Troubleshooting
“The display shows nothing.”
• Is the power turned on properly?
• Is the monitor powered on?
• Are the unit and monitor properly connected?
• Is mute active?
• Could you be playing an empty movie?
“The image shows horizontally narrow. Text, logos
show vertically rectangular.”
• Could you be projecting a 16:9 project on a 4:3 display?
“Setting the aspect ratio of the display”
“The unit doesn’t function as scheduled.”
• Is the internal clock properly set?
“Adjusting the internal clock”
• Is the Play Mode properly set?
“Playing movies in the Play Mode”
“The day of the week doesn’t match properly with
the date.”
• Is the year set properly?
“Adjusting the internal clock”
“The time doesn’t keep properly.”
• The accuracy of the internal clock may deviate by up to two
seconds a day. To maintain accuracy, you are advised to adjust
the time once a day.
“The unit shuts down, or reboots unexpectedly.”
• Could a shutdown event or reboot event be set for the
scheduler?
“Programming a schedule to control this unit”
“Cannot hear any sound. The sound is too low.”
• Could the volume on the panel be turned down?
• Could “Balance” in the SOUND INFORMATION screen be set
to “External”?
“Detailed settings for the sound”
• Could the “AUDIO THRU VOLUME” in the SYSTEM SETTING
screen be turned down?
“Adjusting the volume level balance between external
connected devices and this unit”
“The loading time of the MOVIE EDITOR screen is
too long.”
• The loading time of palettes depends on the amount of
materials it holds. Especially, long sound materials may enlarge
the size.
• Erase unused materials if any.
“The mouse doesn’t function.”
• Is the supplied mouse connected properly?
• Could you be using any equipment other than the supplied
mouse, optional MIDI adaptor, etc.?
If so, shut down and power off the unit, and reboot after a
while. The mouse will be recognized properly.
“MIDI doesn’t function properly.”
• Did you connect MIDI properly?
For a MIDI connection, you need to use the separately available
UM-1X. If this wasn’t used, shut down and power off the unit,
check the connection, and reboot again. Also, MIDI doesn’t
function when connected after the unit is powered on.
“The fan keeps turning even after shutdown.”
• In standby mode, a part of the system is kept energized to
enable rebooting from the panel, and thus keeps the fan turning
to cool down the unit. If you wish to cut the standby electricity,
press POWER on the unit to power off, or power off the system
to which the power supply is connected.
000RG-100.book 121 ページ ２００４年８月６日 金曜日 午後５時３７分
